Gigabyte G481-HA0 - Page 65

- 65 - BIOS Setup
Parameter
Description
Advanced NIC
Conguration
Press [Enter] to congure advanced items.

Debug Options
– Allows users to congure link initialization in pre-boot.
– Options available: Auto/Enabled/Disabled. Default setting is Auto.

Use a custom P_Key value
– Select 'Yes' to use a custom P_Key value or boot over fabric (instead of a
default one.)
– Options available: No/Yes.

Custom P_Key value (hexadecimal)
– This item cannot be congured if Use a custom P_Key value is set to No.
– This P_Key value will be used for boot over fabric. The 'full membership' bit
(0x8000) will be always set automatically.
UEFI Driver
Displays the technical specications for the Advanced Network Interface Controller.
Device Name
Displays the technical specications for the Advanced Network Interface Controller.
PCI Device ID
Displays the technical specications for the Advanced Network Interface Controller.
PCI Address
Displays the technical specications for the Advanced Network Interface Controller.
Port GUID
Displays the technical specications for the Advanced Network Interface Controller.
Fabric Link State
Displays the technical specications for the Advanced Network Interface Controller.
Fabric Link Speed
Displays the technical specications for the Advanced Network Interface Controller.
Fabric Link Width
Displays the technical specications for the Advanced Network Interface Controller.