6VXE7+
4-10
•
Boot From LAN First
The default value is Disabled.
Enabled Enable Boot From LAN First.
Disabled Disable Boot From LAN First.
AUTO
Auto detect Boot From LAN First.
•
Boot Sequence
This category determines which drive computer searches first for the disk
operating system (i.e., DOS). Default value is A, C, SCSI.
X1, X2, X3 System will first search for X1 disk drive then X2 disk drive
and then X3 disk drive.
•
VGA Boot From
The default value is AGP
AGP System will boot from AGP Display Card.
PCI Slot System will boot from PCI Slot VGA Card.
•
Boot Up Floppy Seek
During POST, BIOS will determine the floppy disk drive installed is 40 or 80
tracks. 360
K type is 40 tracks 720
K, 1.2
M and 1.44
M are all 80 tracks.
The default value is Enabled.
Enabled BIOS searches for floppy disk drive to determine it is 40 or
80 tracks. Note that BIOS can not tell from 720
K, 1.2
M or
1.44
M drive type as they are all 80 tracks.
Disabled BIOS will not search for the type of floppy disk drive by track
number. Note that there will not be any warning message if
the drive installed is 360
K.
•
Boot Up NumLock Status
The default value is On.
On Keypad is number keys.
Off Keypad is arrow keys.
To Next Page
Loading...
