Gigabyte GA-6OMM7E - User Manual

FCC Compliance Statement:
This equipment has been tested and found to
comply with limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable
protection against harmful interference in
residential installations. This equipment
generates, uses, and can radiate radio
frequency energy, and if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause interference to radio or
television equipment reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna
-Move the equipment away from the receiver
-Plug the equipment into an outlet on a circuit different from that to which
the receiver is connected
-Consult the dealer or an experienced radio/television technician for
additional suggestions
You are cautioned that any change or modifications to the equipment not
expressly approve by the party responsible for compliance could void Your
authority to operate such equipment.
This device complies with Part 15 of the FCC Rules. Operation is subjected to
the following two conditions 1) this device may not cause harmful interference
and 2) this device must accept any interference received, including interference
that may cause undesired operation.
DECLARATION OF CONFORMITY
Per FCC Part 2 Section 2. 1077(a)
Responsible Party Name: G.B.T. INC.
Address: 18305 Valle
y
Blvd., Suite#A
LA Puent, CA 91744
Phone/Fax No: (818) 854-9338/ (818) 854-9339
hereby declares that the product
Product Name:
Model Number:
Mother Board
Conforms to the following specifications:
FCC Part 15, Subpart B, Section 15.107(a) and Section 15.109(a),
Class B Digital Device
Supplementary Information:
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful
and (2) this device must accept any inference received, including
that may cause undesired operation.
Representative Person's Name: ERIC LU
Signature:
Date: Jun. 13, 2000
Eric Lu
GA-6OMM7E

Gigabyte GA-6OMM7E Specifications

General

Brand	Gigabyte
Model	GA-6OMM7E
Category	Motherboard
Language	English

Summary

Declaration of Conformity

How This Manual Is Organized

Revision History

Item Checklist

Summary Of Features

6 OMM7 E Motherboard Layout

CPU Speed Setup

Connectors

Game & Audio Port

Details for the game port and audio input/output connectors.

COM A; COM B; VGA; LPT Port

Pinouts and identification for serial, VGA, and parallel ports.

USB Connector

Pin definition for standard USB connectors.

USB & LAN Connector

Pin definition for USB and optional LAN connectors.

PS;2 Keyboard & PS;2 Mouse Connector

Pin definition for PS/2 keyboard and mouse connectors.

CPU Fan Connector (J1)

Pin definition and function for the CPU fan header.

Power Fan Connector (J2)

Pin definition and function for the power fan header.

System Fan Connector (J14)

Pin definition and function for the system fan header.

ATX Power Connector

Pinout for the main ATX power supply connection.

IR;CIR Connector (JP13)

Pin definition for the Infrared (IR) and Consumer IR (CIR) connector.

Floppy Port

Connection details for the floppy disk drive.

IDE Ports (IDE1;IDE2)

Pin definition for primary and secondary IDE device connections.

Ring Power On Connector (J13)

Pin definition for wake-up function via internal modem.

Wake On LAN Connector (J12)

Pin definition for wake-up function via network.

TEL Connector (J7)

Connector definition for modem with internal voice capability.

AUX IN Connector (J6)

Pin definition for auxiliary audio input.

CD Audio Line In (J5)

Pin definition for CD audio input connection.

STR LED Connector & DIMM LED (JP7)

Connectors for Suspend-to-RAM status LED and DIMM status LED.

Front USB Port Connector (JP32)

Pin definition for front panel USB ports.

Extra SMBUS Connector (J10)

Pin definition for the System Management Bus (SMBUS) connector.

DFP;TV Connector (CN8)

Connector for Digital Flat Panel and TV-Out daughter cards.

Panel And Jumper Definition

2 x11 Pins Jumper (J11)

Definition and function of the 2x11 pin jumper block.

Optional for PB Jumper (JP30)

Definition of the JP30 jumper for optional features.

Clear CMOS Function Jumper (JP18)

How to use the JP18 jumper to clear CMOS settings.

Safe Mode;Recovery;Normal Jumper (JP15)

Jumper settings for safe mode, recovery, and normal operation.

Case Open Jumper (JP22)

Jumper for detecting if the computer case has been opened.

STR Enable Jumper (JP4)

Jumper setting to enable or disable Suspend-to-RAM.

PS;2 Keyboard Power On Jumper (JP3)

Jumper for enabling power-on using the PS/2 keyboard.

USB Device Wake up Jumper (JP1)

Jumper for enabling wake-up via USB devices.

FWH Flash ROM Write Protect Jumper (JP20)

Jumper to protect the FWH Flash ROM from writing.

Top Block Lock Jumper (JP21)

Jumper for enabling or disabling top block lock feature.

CPU Speed Up Jumper (JP5)

Jumper for CPU speed enhancement (Magic Booster).

DIMM Over Voltage Jumper (JP6)

Jumper for enabling DIMM over voltage settings.

Internal Buzzer Jumper (JP12)

Jumper to enable or disable the internal buzzer.

Timeout Reboot Jumper (JP14)

Jumper for configuring the timeout reboot function.

PCI;AGP 3 VAUX Jumper (JP23)

Jumper for enabling PCI/AGP 3VAUX feature.

CNR Selection Jumper (JP24)

Jumper for CNR (Communication and Networking Riser) selection.

Cyrix CPU Turbo Function Jumper (JP2)

Jumper to enable Cyrix CPU turbo function.

On Board LAN Function Jumper (JP34)

Jumper to enable or disable the onboard LAN function.

Front USB Keyboard Wake Up Jumper (JP31)

Jumper for enabling wake-up via front USB keyboard.

Battery (BAT1)

Information and precautions regarding the system battery.

Performance List

Block Diagram

Suspend To RAM Installation (Optional)

Introduce STR function

Explanation of the Suspend-to-RAM (STR) sleep mode function.

STR function Installation

Step-by-step guide for installing the STR function.

How to put your system into STR mode?

Instructions on how to activate the system's STR sleep mode.

Define system power on button for STR sleep mode

Configuring the power button to initiate STR sleep mode.

How to recover from STR sleep mode?

Methods for waking the system from STR sleep mode.

STR Notices

Important hardware and software requirements for STR function.

Memory Installation

Page Index for BIOS Setup

BIOS Setup

ENTERING SETUP

Procedure to access the BIOS setup utility.

CONTROL KEYS

Explanation of keyboard shortcuts used within BIOS setup.

GETTING HELP

How to access help information within the BIOS setup.

The Main Menu

Overview of the main navigation screen in BIOS setup.

Standard CMOS Features

Settings for basic system configuration like date, time, and drives.

Advanced BIOS Features

Configuration options for enhanced BIOS functionalities.

Advanced Chipset Features

Settings related to the motherboard chipset's performance and features.

Integrated Peripherals

Configuration for onboard devices like IDE, USB, and audio.

Power Management Setup

Options for controlling system power consumption and sleep modes.

PnP;PCI Configurations

Settings for Plug and Play and PCI device resource allocation.

PC Health Status

Monitoring system temperature, voltage, and fan speeds.

Frequency;Voltage Control

Adjustments for CPU clock ratio and voltage settings.

Load Fail-Safe Defaults

Loading system parameters for maximum stability.

Load Optimized Defaults

Loading factory default settings for optimal performance.

Set Supervisor password

Setting a supervisor password to restrict system access.

Set User password

Setting a user password for limited system access.

Save & Exit Setup

Saving BIOS configuration changes and exiting the setup utility.

Exit Without Saving

Discarding BIOS changes and exiting the setup utility.

Appendix A: Intel 815 Chipset Driver Installation

Windows 9 x INF Update Utility

Guide for installing the INF update utility for Intel 815 chipset.

B: Intel 815 Chipset VGA Graphics Driver Installation

C: SigmaTel Sound Driver Installation

D. Intel ICH IDE ATA66 Driver Installation

Appendix B: BIOS Flash Procedure

Appendix C: Issues To Beware Of When Installing CNR

Appendix D: Issues To Beware Of When Installing GA-AIMM Card (Optional)

Appendix E: Acronyms