BIOS Setup
72
Set Supervisor / User Password
When you select this function, the following message will appear at the center of the screen to
assist you in creating a password.
Figure 13: Password Setting
Type the password, up to eight characters, and press <Enter>. The password typed now will clear
the previously entered password from CMOS memory. You will be asked to confirm the password.
Type the password again and press <Enter>. You may also press <Esc> to abort the selection and
not enter a password.
To disable password, just press <Enter> when you are prompted to enter password. A message
“PASSWORD DISABLED” will appear to confirm the password being disabled. Once the password
is disabled, the system will boot and you can enter Setup freely.
If you select “System” at “Security Option” in BIOS Features Setup Menu, you will be prompted for
the password every time the system is rebooted or any time you try to enter Setup Menu. If you
select “Setup” at “Security Option” in BIOS Features Setup Menu, you will be prompted only when
you try to enter Setup.
CMOS Setup Utility-Copyright( C ) 1984-2000 Award Software
Standard CMOS Features
Frequency/Voltage Control
Advanced BIOS Features
Load Fail-Safe Defaults
Advanced Chipset Features Load Optimized Defaults
Integrated Peripherals
Set Supervisor Password
Power Management Setup Set User Password
PnP/PCI Configurations Save & Exit Setup
PC Health Status Exit Without Saving
ESC:Quit
↑↓→
←
: Select Item
F10:Save & Exit Setup
Change / Set / Disable Password
Enter Password:
To Next Page
Loading...
