Hardware Installation Process
English
- 31 -
+
_
14) RAM_LED
Do not remove memory modules while RAM_LED is on. It might cause short or other unexpected
damages due to the stand by voltage. Remove memory modules only when AC power cord is
disconnected.
+
_
15) 2X_DET
When an AGP 2X (3.3V) card is installed the 4X_AGP will light up, indicating a non-supported
graphics card is inserted. Informing users that system might not boot up normally due to AGP 2X
(3.3V) is not supported by the chipset.
¥¼©R¦W-1 2005/5/5, ¤W¤È 11:4431
To Next Page
Loading...
