BIOS Setup- 37 -
English
Password Check
Setup The system will boot but will not access to Setup page if the correct password is not
entered at the prompt. (Default value)
System The system will not boot and will not access to Setup page if the correct password is
not entered at the prompt.
If you want to cancel the setting of password, please just press ENTER to make [SETUP] empty.
CPU Hyper-Threading
Enabled Enables CPU Hyper Threading Feature. Please note that this feature is only working
for operating system with multi processors mode supported. (Default value)
Disabled Disables CPU Hyper Threading.
Limit CPUID Max. to 3
Enabled Limit CPUID Maximum value to 3 when use older OS like NT4. (Default value)
Disabled Disables CPUID Limit for windows XP.
No-Execute Memory Protect
(Note)
Enabled Enables No-Execute Memory Protect function.
Disabled Disables No-Execute Memory Protect function. (Default value)
CPU Enhanced Halt (C1E)
(Note)
Enabled Enables CPU Enhanced Halt (C1E) function.
Disabled Disables CPU Enhanced Halt (C1E) function. (Default value)
CPU Thermal Monitor 2 (TM2)
(Note)
Enabled Enable CPU Thermal Monitor 2 (TM2) function.
Disabled Disable CPU Thermal Monitor 2 (TM2) function. (Default value)
Init Display First
This feature allows you to select the first initiation of the monitor display from which card when you
install a PCI card and a PCI Express VGA card on the motherboard.
In order to enable the Dual Graphic function correctly, you have to connect the display cable to the
graphic card in the PCIE_16_2 slot and set this item to PEG2.
PCI Set Init Display First to PCI VGA card.
PEG Set Init Display First to PCI Express VGA card (Slot1). (Default value)
PEG2 Set Init Display First to PCI Express VGA card (Slot2) card.
(Note) This item will show up when you install a processor which supports this function.
To Next Page
Loading...
