Gigabyte GA-970A-D3 - 2-5 Advanced BIOS Features

- 41 - BIOS Setup
2-5 Advanced BIOS Features
Load Line Control
Enables or disables Load Line control. This item allows you to adjust Vdroop at different levels. Enabling
Load Line control may keep the CPU voltage more constant under light and heavy CPU load. Auto lets the
BIOS automatically congure this setting. (Default: Auto)
AMD C1E Support
Enables or disables the C1E CPU power-saving function in system halt state. When enabled, the power
consumption will be reduced during system halt state.
Auto If a CPU that supports hardware C1E is installed, the BIOS will automatically enable
the hardware C1E function. If not, the C1E function will be disabled. (Default)
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
Advanced BIOS Features
Item Help
Menu Level

(Note) This item is present only when you install a CPU that supports this feature.
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
Advanced BIOS Features
Load Line Control [Auto]
AMD C1E Support [Auto]
AMD C6 Support [Enabled]
Virtualization [Disabled]
AMD K8 Cool&Quiet control [Auto]
AMD APM Master Mode [Auto]
CPU core Control
(Note)
[Auto]
x One Core Per Compute Unit
(Note)
Disabled
x CPU core 1-2
(Note)
Enabled
x CPU core 3-4
(Note)
Enabled
x CPU core 5-6
(Note)
Enabled
x CPU core 7-8
(Note)
Enabled

Hard Disk Boot Priority [Press Enter]
EFI CD/DVD Boot Option [Auto]
First Boot Device [Hard Disk]
Second Boot Device [CDROM]
Third Boot Device [USB-FDD]
Password Check [Setup]
HDD S.M.A.R.T. Capability [Disabled]
higf
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level

CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
Advanced BIOS Features
higf
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level

Away Mode [Disabled]
Full Screen LOGO Show [Enabled]
IOMMU support [Disabled]
Init Display First [PCI Slot]