Gigabyte GA-970A-D3 - Page 46

BIOS Setup - 46 -
Start detecting at Port.....
Link Detected --> 100Mbps
Cable Length= 30m
Link Detected Displays transmission speed.
Cable Length Displays the approximate length of the attached LAN cable.
Note: The Gigabit hub will only operate at a speed of 10/100 Mbps in MS-DOS mode; it will operate at a
normal speed of 10/100/1000 Mbps in Windows mode or when the LAN Boot ROM is activated.
When a Cable Problem Occurs...
 Ifacableproblemoccursonaspeciedpairofwires,theStatuseldwillshowShort and then length
shown will be the approximate distance to the fault or short.
Example: Part1-2 Status = Short / Length = 2m
Explanation: A fault or short might occur at about 2m on Part 1-2.
 Note:Part4-5andPart7-8arenotusedina10/100Mbpsenvironment,sotheirStatuseldswillshow
Open,andthelengthshownistheapproximatelengthoftheattachedLANcable.
When LAN Cable Is Functioning Normally...
 IfnocableproblemisdetectedontheLANcableconnectedtoaGigabithubora10/100Mbpshub,the
following message will appear:
Onboard Audio Function
Enables or disables the onboard audio function. (Default: Enabled)
 Ifyouwishtoinstalla3rdpartyadd-inaudiocardinsteadofusingtheonboardaudio,setthisitemto
Disabled.
USB30 Controller (Etron EJ168 USB Controller)
Enables or disables the Etron EJ168 USB controller. (Default: Enabled)
USB Controllers
Enables or disables the integrated USB controllers. (Default: Enabled)
Disabled will turn off all of the USB functionalities below.
USB Legacy Function
Allows USB keyboard to be used in MS-DOS. (Default: Enabled)
USB Storage Function
 DetermineswhethertodetectUSBstoragedevices,includingUSBashdrivesandUSBharddrivesduring
the POST. (Default: Enabled)
Onboard Serial Port 1
 EnablesordisablestheserialportandspeciesitsbaseI/Oaddressandcorrespondinginterrupt.Options
are:Auto,3F8/IRQ4(default),2F8/IRQ3,3E8/IRQ4,2E8/IRQ3,Disabled.