- 13 -
7) CLR_CMOS (Clear CMOS Jumper)
• Always turn off your computer and unplug the power cord from the power outlet before clearing the CMOS values.
•
Open: Normal
Short: Clear CMOS Values
6) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The AMD SB950 controller supports
RAID 0, RAID 1, RAID 5, RAID 10, and JBOD.
•
be used, the total number of hard drives must be an even number.
•
•
• To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Peripherals\SB SATA
Pin No.
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
8) BAT (Battery)
computer is turned off. Replace the battery when the battery voltage drops to a low level, or the CMOS
values may not be accurate or may be lost.
0 2 4
1 3 5
7 7 7
1 1 1
SATA3
You may clear the CMOS values by removing the battery:
1. Turn off your computer and unplug the power cord.
2.
3. Replace the battery.
4. Plug in the power cord and restart your computer.
• Always turn off your computer and unplug the power cord before replacing the battery.
• Replace the battery with an equivalent one. Danger of explosion if the battery is replaced with an incorrect model.
• Contact the place of purchase or local dealer if you are not able to replace the battery by yourself or uncertain
about the battery model.
•
• Used batteries must be handled in accordance with local environmental regulations.
To Next Page
Loading...
