Gigabyte GA-990FXA-UD3 - 2-4 Standard CMOS Features

- 41 - BIOS Setup
2-4 Standard CMOS Features
Date (mm:dd:yy)
 Setsthesystemdate.Thedateformatisweek(read-only),month,dateandyear.Selectthedesiredeld
and use the up arrow or down arrow key to set the date.
Time (hh:mm:ss)
 Setsthesystemtime.Forexample,1p.m.is13:0:0.Selectthedesiredeldandusetheuparrowor
down arrow key to set the time.
IDE Channel 0, 1 Master/Slave
IDE HDD Auto-Detection
Press <Enter> to autodetect the parameters of the SATA device on this channel.
IDE Channel 0, 1 Master/Slave
 CongureyourSATAdevicesbyusingoneofthetwomethodsbelow:
• Auto   LetstheBIOSautomaticallydetectSATAdevicesduringthePOST.(Default)
• None If no SATA devices are used, set this item to None so the system will skip
      thedetectionofthedeviceduringthePOSTforfastersystemstartup.
AccessMode  Setstheharddriveaccessmode.Optionsare:Auto(default),CHS,LBA,Large.
IDE Channel 2, 4 Master/Slave
IDE Auto-Detection
Press <Enter> to autodetect the parameters of the SATA device on this channel.
Extended IDE Drive
 CongureyourSATAdevicesbyusingoneofthetwomethodsbelow:
• Auto   LetstheBIOSautomaticallydetectSATAdevicesduringthePOST.(Default)
• None If no SATA devices are used, set this item to None so the system will skip
      thedetectionofthedeviceduringthePOSTforfastersystemstartup.
AccessMode  Setstheharddriveaccessmode.Optionsare:Auto(default),Large.
Capacity Approximate capacity of the currently installed hard drive.
CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
Standard CMOS Features
Date (mm:dd:yy) Wed, Mar 16 2011
Time (hh:mm:ss) 22:31:24
}
IDE Channel 0 Master [None]
}
IDE Channel 0 Slave [None]
}
IDE Channel 1 Master [None]
}
IDE Channel 1 Slave [None]
}
IDE Channel 2 Master [None]
}
IDE Channel 2 Slave [None]
}
IDE Channel 4 Master [None]
}
IDE Channel 4 Slave [None]
Halt On [All, But Keyboard]
Base Memory 640K
Extended Memory 1022M

: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level
}