Gigabyte GA-990FXA-UD5 - Page 11

- 11 -
Hardware Installation
Storage Interface  South Bridge:
 - 6xSATA6Gb/sconnectors(SATA30~SATA35)supportingupto6SATA
6Gb/s devices
- Support for RAID 0, RAID 1, RAID 5, RAID 10, and JBOD
 2 x Marvell 88SE9172 chips:
 - 2xSATA6Gb/sconnectors(GSATA36/7) supporting up to 2 SATA 6Gb/s
devices
- 2 x eSATA 6Gb/s connectors on the back panel supporting up to 2 SATA
6Gb/s devices
- Support for RAID 0 and RAID 1
USB  South Bridge:
- Upto14USB2.0/1.1ports(8portsonthebackpanel,6portsavailable
throughtheinternalUSBheaders)
 2 x Etron EJ168 chips:
- Upto4USB3.0/2.0ports(2portsonthebackpanel,2portsavailablethrough
theinternalUSBheader)
* BesuretoconnectyourUSBdevice(s)totheUSB2.0/1.1portsbeforetheUSB3.0
driverisinstalled.(Refertothelabelsinsection1-7,"BackPanelConnectors.")
IEEE 1394  VIA VT6308 chip:
 - Upto2IEEE1394aports(1portonthebackpanel,1portavailablethrough
theinternalIEEE1394aheader)
Internal
Connectors
 1 x 24-pin ATX main power connector
 1 x 8-pin ATX 12V power connector
 8 x SATA 6Gb/s connectors
 1 x CPU fan header
 2 x system fan headers
 1 x power fan header
 1 x front panel header
 1 x front panel audio header
 1 x S/PDIF Out header
 1 x USB 3.0/2.0 header
 3 x USB 2.0/1.1 headers
 1 x IEEE 1394a header
 1 x serial port header
 1 x Clear CMOS jumper
 1xTrustedPlatformModule(TPM)header
Back Panel
Connectors
 1 x PS/2 keyboard/mouse port
 1 x optical S/PDIF Out connector
 1 x IEEE 1394 port
 2 x USB 3.0/2.0 ports
 8 x USB 2.0/1.1 ports
 2 x eSATA 6Gb/s connectors
 1 x RJ-45 port
 6 x audio jacks(Center/SubwooferSpeakerOut, Rear Speaker Out,
SideSpeakerOut,LineIn,LineOut,MicIn)