Gigabyte GA-990FXA-UD7 - Page 50

BIOS Setup
- 50 -
& VIA 1394 Controller
 EnablesordisablestheonboardIEEE1394function.(Default:Enabled)
& OnChip SATA Controller (AMD SB950)
 EnablesordisablestheintegratedSATAcontrollers.(Default:Enabled)
& OnChip SATA Type (AMD SB950, SATA3 0~3 connectors)
 EnablesordisablesRAIDfortheSATAcontrollersintegratedintheChipsetorcongurestheSATAcontrollers
to AHCI mode.
NativeIDE CongurestheSATAcontrollertoIDEmode.
RAID Enables RAID for the SATA controller.
AHCI   CongurestheSATAcontrollerstoAHCImode.AdvancedHostControllerInterface
(AHCI)isaninterfacespecicationthatallowsthestoragedrivertoenableadvanced
SerialATAfeaturessuchasNativeCommandQueuingandhotplug.(Default)
& OnChip SATA Port4/5 Type (AMD SB950, SATA3 4/SATA3 5 connectors)
 ThisoptioniscongurableonlywhenOnChip SATA Type is set to RAID or AHCI.Congurestheoperating
modeoftheintegratedSATA34~SATA35connectors.
As SATA Type The mode depends on the OnChip SATA Type settings.
IDE   CongurestheSATA34~SATA35connectorstoIDEmode.(Default)
& HD Audio Azalia Device
 Enablesordisablestheonboardaudiofunction.(Default:Enabled)
If you wish to install a 3rd party add-in audio card instead of using the onboard audio, set this item to
Disabled.
& Onboard USB Device
 EnablesordisablestheintegratedUSBcontroller.(Default:Enabled)
& Onboard LAN Controller
 EnablesordisablestheonboardLANfunction.(Default:Enabled)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to
Disabled.
& F_USB30 Controller (Etron
®
EJ168 USB Controller, USB 3.0/2.0 ports routed to the on-
board F_USB30 header)
Enables or disables the Etron
®
EJ168USBcontroller.(Default:Enabled)
& Onboard GSATA Controller (Marvell
®
88SE9172 chip, GSATA3 6/GSATA3 7 connectors)
Enables or disables the SATA controller integrated in the Marvell
®
88SE9172chip.(Default:Enabled)
& R_USB3.0 Controller (Etron
®
EJ168 USB Controller, USB 3.0/2.0 ports on the back
panel)
Enables or disables the Etron
®
EJ168USBcontroller.(Default:Enabled)
& Onboard eSATA Controller (Marvell
®
88SE9172 chip, eSATA connectors on the back
panel)
Enables or disables the SATA controller integrated in the Marvell
®
88SE9172chip.(Default:Enabled)
& Legacy USB Support
 AllowsUSBkeyboard/mousetobeusedinMS-DOS.(Default:Enabled)
& XHCI Hand-off
Determines whether to enable XHCI Hand-off feature for an operating system without XHCI Hand-off
support.(Default:Enabled)