For the Marvell
®
88SE9172:
Step 1:
Copy the Marvell folder under BootDrv in the driver disk to your USB thumb drive.
Step 2:
Boot from the Windows 8/7 setup disk and perform standard OS installation steps. When the screen requesting
you to load the driver appears, select Browse.
Step 3:
Insert the USB thumb drive and then browse to the location of the driver. The locations of the drivers are as follows:
RAID driver for Windows 32-bit: \Marvell\RAID\Floppy32
RAID driver for Windows 64-bit: \Marvell\RAID\Floppy64
AHCI driver for Windows 32-bit: \Marvell\AHCI\Floppy32
AHCI driver for Windows 64-bit: \Marvell\AHCI\Floppy64
Step 4:
When a screen as shown in Figure 2 appears, select Marvell 91xx SATA 6G RAID Controller and click Next
to load the driver and continue the OS installation.
Figure 2
To Next Page
Loading...
