Gigabyte GA-990FXA-UD7 - Page 76

Conguring SATA Hard Drive(s)
- 76 -
Figure 5
For the Marvell
®
88SE9172:
Step 2:
InserttheoppydiskcontainingtheSATARAID/AHCIdriverandpress<Enter>.BothoftheMarvell shared
library and Marvell 91xx SATA Controller need to be installed. Below we assume that you are installing the
32-bit version. First select Marvellsharedlibrary(installrst) and press <Enter>. On the next screen, press <S>
to return to the screen in Figure 5. Then select Marvell 91xx SATA Controller 32bit Driver and press <Enter>.
Whenbothofthetwodriversappearontheconrmationscreen,press<Enter>tocontinuethedriverinstallation.
Windows Setup
You have chosen to congure a SCSI Adapter for use with Windows,
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to return to the previous screen.
ENTER=Select F3=Exit
Marvell shared library (install rst)
Marvell 91xx SATA RAID Controller 32bit Driver
Step 3:
On the next screen, press <Enter> to continue the driver installation. After the driver installation, you can proceed
with the Windows XP installation.