Gigabyte GA-A75M-DS2 - Peripherals

- 35 -
& Ipv4PXESupport
 EnablesordisablesIPv4PXESupport.ThisitemiscongurableonlywhenNetworkstack is enabled.
& Ipv6PXESupport
 EnablesordisablesIPv6PXESupport.ThisitemiscongurableonlywhenNetworkstack is enabled.
& Administrator Password
 Allowsyoutocongureanadministratorpassword.Press<Enter>onthisitem,typethepassword,and
thenpress<Enter>.Youwillberequestedtoconrmthepassword.Typethepasswordagainandpress
<Enter>.Youmustentertheadministratorpassword(oruserpassword)atsystemstartupandwhenentering
BIOS Setup. Differing from the user password, the administrator password allows you to make changes to
all BIOS settings.
& User Password
 Allowsyoutocongureauserpassword.Press<Enter>onthisitem,typethepassword,andthenpress
<Enter>.Youwillberequestedtoconrmthepassword.Typethepasswordagainandpress<Enter>.
Youmustentertheadministratorpassword(oruserpassword)atsystemstartupandwhenenteringBIOS
Setup. However, the user password only allows you to make changes to certain BIOS settings but not all.
To cancel the password, press <Enter> on the password item and when requested for the password, enter the
correctonerst.Whenpromptedforanewpassword,press<Enter>withoutenteringanypassword.Press
<Enter>againwhenpromptedtoconrm.
2-6 Peripherals
& OnChipSATAController
 EnablesordisablestheintegratedSATAcontrollers.(Default:Enabled)
& OnChipSATAType
 EnablesordisablesRAIDfortheSATAcontrollersintegratedintheAMDChipsetorcongurestheSATA
controllers to AHCI mode.
IDE   CongurestheSATAcontrollertoIDEmode.(Default)
RAID Enables RAID for the SATA controller.