Gigabyte GA-G41MT-S2 - Page 22

- 22 -
Whether the system will work stably with the overclock/overvoltage settings you made is dependent
on your overall system congurations. Incorrectly doing overclock/overvoltage may result in damage
to CPU, chipset, or memory and reduce the useful life of these components. This page is for advanced
users only and we recommend you not to alter the default settings to prevent system instability or
other unexpected results. (Inadequately altering the settings may result in system's failure to boot. If
this occurs, clear the CMOS values and reset the board to default values.)
Robust Graphics Booster &
Robust Graphics Booster (R.G.B.) helps to enhance the performance of the graphics chip and memory.
Auto allows the BIOS to automatically set the R.G.B. mode based on system congurations. Options are:
Auto (default), Fast, Turbo.
CPU Clock Ratio &
(Note)
Allows you to alter the clock ratio for the installed CPU.
The item is present only if a CPU with unlocked clock ratio is installed.
Fine CPU Clock Ratio &
(Note)
Allows you to increase clock ratio by 0.5 for the installed CPU.
The item is present only if a CPU with unlocked clock ratio is installed.
CPU Frequency &
Displays the current operating CPU frequency.
********
Clock Chip Control
********
>>>>> Standard Clock Control
CPU Host Clock Control &
Enables or disables the control of CPU host clock. Enabled will allow the CPU Host Frequency item below
to be congurable. Note: If your system fails to boot after overclocking, please wait for 20 seconds to allow
for automated system reboot, or clear the CMOS values to reset the board to default values. (Default:
Disabled)
(Note) This item is present only when you install a CPU that supports this feature.
CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
MB Intelligent Tweaker(M.I.T.)

: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level
`
x CAS Latency Time 9 Auto
x tRCD 9 Auto
x tRP 9 Auto
x tRAS 24 Auto
>>>>> Advanced Timing Control
`
Advanced Timing Control [Press Enter]
********
Mother Board Voltage Control
********
Voltage Types Normal Current
-----------------------------------------------------------------------------
>>> CPU
CPU Vcore 1.17500V [Auto]
CPU Termination 1.200V [Auto]
>>> DRAM
DRAM Voltage 1.500V [Auto]