- 33 -
(Note) Supported on Windows 7/Vista operating system only.
Soft-Off by PWR-BTTN &
Congures the way to turn off the computer in MS-DOS mode using the power button.
Instant-Off Press the power button and then the system will be turned off instantly. (Default)
Delay 4 Sec. Press and hold the power button for 4 seconds to turn off the system. If the power
button is pressed for less than 4 seconds, the system will enter suspend mode.
PME Event Wake Up &
Allows the system to be awakened from an ACPI sleep state by a wake-up signal from a PCI or PCIe
device. Note: To use this function, you need an ATX power supply providing at least 1A on the +5VSB
lead. (Default: Enabled)
Power On by Ring &
Allows the system to be awakened from an ACPI sleep state by a wake-up signal from a modem that
supports wake-up function. (Default: Enabled)
Resume by Alarm &
Determines whether to power on the system at a desired time. (Default: Disabled)
If enabled, set the date and time as following:
Date (of Month) Alarm: Turn on the system at a specic time on each day or on a specic day in a
month.
Time (hh: mm: ss) Alarm: Set the time at which the system will be powered on automatically.
Note: When using this function, avoid inadequate shutdown from the operating system or removal of the
AC power, or the settings may not be effective.
HPET Support &
(Note)
Enables or disables High Precision Event Timer (HPET) for Windows 7/Vista operating system.
(Default: Enabled)
HPET Mode &
(Note)
Allows you to select the HPET mode for your Windows 7/Vista operating system. This item is
congurable only if the HPET Support is set to Enabled. (Default: 32-bit mode)
Power On By Mouse &
Allows the system to be turned on by a PS/2 mouse wake-up event. (Default: Disabled)
Note: To use this function, you need an ATX power supply providing at least 1A on the +5VSB lead.
Double Click Double click on left button on the PS/2 mouse to turn on the system.
Power On By Keyboard &
Allows the system to be turned on by a PS/2 keyboard wake-up event. (Default: Disabled)
Note: you need an ATX power supply providing at least 1A on the +5VSB lead.
Password Set a password with 1~5 characters to turn on the system.
Keyboard 98 Press POWER button on the Windows 98 keyboard to turn on the system.
KB Power ON Password &
Set the password when Power On by Keyboard is set to Password. Press <Enter> on this item and
set a password with up to 5 characters and then press <Enter> to accept. To turn on the system, enter
the password and press <Enter>.
Note: To cancel the password, press <Enter> on this item. When prompted for the password, press
<Enter> again without entering the password to clear the password settings.
To Next Page
Loading...
