- 25 -
20) BATTERY (Battery cable connector)
in the CMOS when the computer is turned off. Replace the battery when the battery voltage drops to a
low level, or the CMOS values may not be accurate or may be lost.
• Always turn off your computer and unplug the power cord before replacing the battery.
• Replace the battery with an equivalent one. Danger of explosion if the battery is replaced with an incorrect model.
• Contact the place of purchase or local dealer if you are not able to replace the battery by yourself or uncertain about the battery
model.
• Used batteries must be handled in accordance with local environmental regulations.
2
1
Pin No.
1 RTC Reset
2 GND
21) CLR_CMOS (Clearing CMOS Jumper)
touch the two pins for a few seconds.
Open: Normal operation (Default setting)
Close: Clear CMOS data
•
Always turn off your computer and unplug the power cord from the power outlet before clearing the
CMOS values.
• After system restart, go to BIOS Setup to load factory defaults (select Load Optimized Defaults) or
To Next Page
Loading...
