Gigabyte GA-M68M-S2P - Onboard Parallel Port; Usb Keyboard Support

- 41 - BIOS Setup
NV SATA 1 Secondary RAID
 EnablesordisablesRAIDforthesecondchanneloftherstintegratedSATA3Gb/scontroller.Thisitem
iscongurableonlyiftheNV SATA RAID function item is set to Enabled. (Default: Enabled)
NV SATA 2 Primary RAID
 EnablesordisablesRAIDfortherstchannelofthesecondintegratedSATA3Gb/scontroller.Thisitem
iscongurableonlyiftheNV SATA RAID function item is set to Enabled. (Default: Enabled)
NV SATA 2 Secondary RAID
 EnablesordisablesRAIDfortherstchannelofthesecondintegratedSATA3Gb/scontroller.Thisitem
iscongurableonlyiftheNV SATA RAID function item is set to Enabled. (Default: Enabled)
Onboard Audio Function
Enables or disables the onboard audio function. (Default: Auto)
If you wish to install a 3rd party add-in audio card instead of using the onboard audio, set this item to
Disabled.
On-Chip MAC Lan
Enables or disables the onboard LAN function. (Default: Auto)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to
Disabled.
Onboard LAN Boot ROM
Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip.
(Default: Disabled)
Onboard Serial Port 1
 EnablesordisablestherstserialportandspeciesitsbaseI/Oaddressandcorrespondinginterrupt.
Options are: Auto, 2F8/IRQ3, 3F8/IRQ4(default), 3E8/IRQ4, 2E8/IRQ3, Disabled.
Onboard Parallel Port
 Enablesordisablestheonboardparallelport(LPT)andspeciesitsbaseI/Oaddressandcorrespond-
ing interrupt. Options are: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
Selects an operating mode for the onboard parallel (LPT) port. Options are: SPP (Standard Parallel Port)
(default), EPP (Enhanced Parallel Port), ECP (Extended Capabilities Port), ECP+EPP.
ECP Mode Use DMA
 SelectsDMAchannelfortheLPTportinECPmode.ThisitemiscongurableonlyifParallel Port Mode
is set to ECP or ECP+EPP mode. Options are: 3 (default), 1.
On-Chip USB
V1.1+V2.0 Enables the USB 1.1 and USB 2.0 controllers. (Default)
V1.1 Enables only the USB 1.1 controller.
Disabled Disables the onboard USB controller.
USB Keyboard Support
Allows USB keyboard to be used in MS-DOS. (Default: Disabled)
USB Mouse Support
Allows USB mouse to be used in MS-DOS. (Default: Disabled)
Legacy USB storage detect
 Determineswhether to detect USB storagedevices, including USB ash drivesandUSB hard drives
during the POST. (Default: Enabled)