Gigabyte GA-MA69G-S3H - Installing the TV out Bracket (Optional)

Appendix- 91 -
English
5-3 Installing the TV Out Bracket (Optional)
A TV output header is available on the motherboard (refer to page 29). Via the use of the TV out bracket,
you can connect a TV to your computer for output of video signals.
• Turn off your system and the power switch on the power supply before installing or
removing the TV out bracket to prevent damage to hardware.
• Securely insert the cable from the TV out bracket into the corresponding motherboard
connector (TV) when installing.
• Simultaneous output for D-Sub and TV (S-Video, AV composite, or YPbPr component) is not
supported. By default, when the onboard D-Sub and TV are connected at the same time, the
D-Sub monior will be the primary display. To change the primary display to your TV, refer
to the instructions on the next page.
TV Out Bracket
(HDTV Component
or AV Composite)
S-Video
Y Pr Pb/AV
Connects to the TV
output connector
Step 1:
Secure the TV out
bracket to the chassis
back panel with a
screw.
Follow the steps below to install the TV out bracket:
Step 3:
Refer to the figures below to connect your video device to the corresponding ports on the TV out bracket.
Step 2:
Connect TV out
bracket connector to
the motherboard TV
output header.
HDTV
NTSC / PAL TV
Projector
or
NTSC / PAL TV Projector
or
S-Video Output
Pr
Y
Pb/AV Output
(Note)
(Note) Simultaneous output for S-Video, AV composite, and YPbPr
component is not supported.