Gigabyte GA-MA78LM-S2 - Making a SATA RAID;AHCI Driver Diskette

- 75 - Appendix
5-1-2 Making a SATA RAID/AHCI Driver Diskette
(Required for AHCI and RAID Mode)
TosuccessfullyinstalloperatingsystemontoSATAharddrive(s)thatis/areconguredtoRAID/AHCImode,
you need to install the SATA controller driver during the OS installation. Without the driver, the hard drive may
not be recognized during the Windows setup process. First of all, copy the driver for the SATA controller from
themotherboarddriverdisktoaoppydisk.ForinstallingWindowsVista,youalsocancopytheSATAcon-
trollerdriverfromthemotherboarddriverdisktoaUSBashdrive.Seetheinstructionsbelowabouthowto
copy the driver in MS-DOS and Windows mode.
In MS-DOS mode:
PrepareastartupdiskthathasCD-ROMsupportandablankformattedoppydisk.
Steps:
1: Boot from the startup disk.
2: Removethestartupdiskandinsertthepreparedoppydiskandthemotherboarddriverdisk(hereweas-
sume that the drive letter for your optical drive is D:\).
3: At the A:\> prompt, type the following command. Press <Enter> after the command:
A:\>copy d:\bootdrv\sb750\x86\*.*
(Note)
Figure 1
Figure 3
Figure 2
(Note) Change the directory from \x86 to \x64 if you wish to copy the Windows 64-bit driver.
In Windows mode:
Steps:
1: Use an alternative system and insert the motherboard driver disk.
2: From your optical drive folder, double click the Menu.exeleintheBootDrv folder (Figure 2). A Command
Prompt window will open similar to that in Figure 3.
3: Insert the blank formatted disk. Select the controller driver by pressing the corresponding letter from the
menu. For example, from the menu in Figure 3, select 3) SB700/710/750 SATA Driver for XP for operat-
ing system.
Yoursystemwillthenautomaticallycopythedriverlestotheoppydisk.Pressanykeytoexitwhennished.