Gigabyte GA-P43-ES3G - Page 37

- 3 7 - BIOS Setup
(G)MCH Frequency Latch
Allows you to fix the chipset frequency at system bootup. Options for adjusting memory multiplier
below may differ according to the fixed frequency. Options are: Auto (default), 200MHz, 266MHz,
333MHz, 400MHz.
System Memory Multiplier (SPD)
Allows you to set the system memory multiplier. Options are dependent on CPU FSB and the
(G)MCH Frequency Latch settings. Auto sets memory multiplier according to memory SPD
data. (Default: Auto)
Memory Frequency (Mhz)
The first memory frequency value is the normal operating frequency of the memory being used;
the second is the memory frequency that is automatically adjusted according to the CPU Host
Frequency (Mhz) and System Memory Multiplier settings.
DRAM Timing Selectable (SPD)
Manual allows all DRAM timing control items below to be configurable.
Options are: Auto (default), Manual.
>>>>> Standard Timing Control
CAS Latency Time
Options are: Auto (default), 3~7.
tRCD
Options are: Auto (default), 1~15.
tRP
Options are: Auto (default), 1~15.
tRAS
Options are: Auto (default), 1~63.
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
Advanced Timing Control
KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
x tRRD 2 Auto
x tWTR 2 Auto
x tWR 4 Auto
x tRFC 28 Auto
x tRTP 2 Auto
x Command Rate (CMD) 0 Auto
>>>>> Channel A
` Channel A Timing Settings [Press Enter]
` Channel A Driving Settings [Press Enter]
>>>>> Channel B
` Channel B Timing Settings [Press Enter]
` Channel B Driving Settings [Press Enter]
Item Help
Menu Level`
********
Advanced Timing Control
********
Advanced Timing Control
tRRD
Options are: Auto (default), 1~15.