Gigabyte GA-Z68X-UD7-B3 - Page 99

- 99 - Appendix
Now, you may proceed to the installation of the SATA driver and operating system.
Delete the RAID Array:
To deleted the existing array, select the array on the main menu (example: VD 0: New_VD) and press <Enter>
to display the Deleteoption.Press<Enter>.Whenprompted,press<Y>toconrmor<N>tocancel(Figure8).
Figure 8
Use the Marvell Storage Utility in the Operating System:
With the Marvell Storage utility, you can set up an array or view the current array status in the operating
system. To install the utility, insert the motherboard driver disk, then go to Application Software\Install Ap-
plication Software and select Marvell Storage Utility to install. Note: After the installation, you must login
the utility with the same account name and password that you use to login the operating system. If you did
not set the account password before, click Login to enter the Marvell Storage Utility directly.
Marvell BIOS Setup (c) 2009 Marvell Technology Group Ltd.
Topology Information
Help
Vendor ID : 1B4B
Device ID : 91A3
Revision ID : B1
BIOS Version : 1.0.0.1029
Firmware Version : 2.2.0.1113
PCIe Speed rate : 5.0Gbps
CongureSATAas : IDEMode
Supported Mode : RAID 0 RAID 1
HBA 0 : Marvell 0
Virtual Disks
New_VD
HDD 0: WDC WD800JD-22L
HDD 1: WDC WD800JD-22L
Free Physical Disks
Marvell RAID on chip controller.
ENTER: Operation F10: Exit/Save ESC: Return
Do you want to delete this virtual disk?
Yes No
Delete Virtual Disk