Gigabyte GA-Z77X-UP7 - Page 102

Appendix
- 102 -
Figure 4
For the Marvell 88SE9172:
Step 2:
InserttheoppydiskcontainingtheSATARAID/AHCIdriverandpress<Enter>.Selecteitherthe32-bitor64-bit
items depending on whether you want to install the 32-bit or 64-bit version of Windows XP (Figure 4). Both of
the Marvell shared library and Marvell 91xx SATA RAID Controller need to be installed. Below we assume
that you are installing the 32-bit version. First select Marvellsharedlibraryfor32bit(installrst) and press
<Enter>. On the next screen, press <S> to return to the screen in Figure 4. Then select Marvell 91xx SATA
RAID Controller 32bit Driverandpress<Enter>.Whenbothofthetwodriversappearontheconrmation
screen, press <Enter> to continue the driver installation.
Windows Setup
You have chosen to congure a SCSI Adapter for use with Windows,
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to return to the previous screen.
ENTER=Select F3=Exit
Marvell shared library for 32bit (install rst)
Marvell 91xx SATA RAID Controller 32bit Driver
Marvell shared library for 64bit (install rst)
Marvell 91xx SATA RAID Controller 64bit Driver
Step 3:
On the next screen, press <Enter> to continue the driver installation. After the driver installation, you can proceed
with the Windows XP installation.