Gigabyte GA-Z87X-UD7 TH - Page 30

- 30 -
Hardware Installation
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
9) GSATA3 6/7/8/9 (SATA 6Gb/s Connectors, Controlled by Marvell
®
88SE9230 Chip)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Marvell
®
88SE9230 chip sup-
portsRAID0,RAID1,andRAID10.RefertoChapter3,"ConguringSATAHardDrive(s),"forinstructions
onconguringaRAIDarray.
7
7
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
1
1
GSATA3
9 7
8 6
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
5 3 1
4 2 0
8) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors, Controlled by Intel
®
Z87 Chipset)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s
standard. Each SATA connector supports a single SATA device. The Intel
®
Chipset supports RAID 0, RAID 1,
RAID5,andRAID10.RefertoChapter3,"ConguringSATAharddrives,"forinstructionsonconguringa
RAID array.
7
1
7
1
DEBUG
PORT
G.QBOFM
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
SATA3
• ARAID0orRAID1congurationrequiresatleasttwoharddrives.Ifmorethantwoharddrives
are to be used, the total number of hard drives must be an even number.
• ARAID5congurationrequiresatleastthreeharddrives.(Thetotalnumberofharddrivesdoes
nothavetobeanevennumber.)
• ARAID10congurationrequiresfourharddrives.