Need help?Do you have a question about the Gigabyte GA-Z97M-D3H and is the answer not in the manual?
General| Non-ECC | Yes |
|---|---|
| Memory channels | Dual-channel |
| Memory slots type | DIMM |
| Number of memory slots | 4 |
| Supported memory types | DDR3-SDRAM |
| Maximum internal memory | 32 GB |
| Supported memory clock speeds | 1333, 1600 MHz |
| Processor socket | LGA 1150 (Socket H3) |
| Processor manufacturer | Intel |
| Compatible processor series | Intel® Celeron® |
| USB 2.0 connectors | 3 |
| Number of SATA connectors | 6 |
| Number of SATA II connectors | - |
| USB 3.2 Gen 1 (3.1 Gen 1) connectors | 1 |
| RAID levels | 0, 1, 5, 10 |
| Supported storage drive interfaces | SATA |
| USB 2.0 ports quantity | 2 |
| Bluetooth | No |
| Audio chip | Realtek ALC892 |
| Component for | PC |
| Power source type | ATX |
| Motherboard chipset | Intel® Z97 |
| Audio output channels | 7.1 channels |
| Motherboard form factor | micro ATX |
| Maximum resolution | 4096 x 2160 pixels |
| Maximum graphics card memory | 1000 MB |
| Parallel processing technology support | 2-Way CrossFireX |
| BIOS type | UEFI AMI |
| ACPI version | 5.0 |
| BIOS memory size | 64 Mbit |
| Bundled software | Norton Internet Security (OEM version)\\r Intel Rapid Start Technology\\r Intel Smart Connect Technology\\r Intel Smart Response Technology |
Weight and Dimensions| Depth | 225 mm |
|---|---|
| Width | 244 mm |
Essential safety and handling procedures before installing hardware.
Guidelines for safely installing the CPU and avoiding damage.
Essential guidelines for safely installing memory modules.
Instructions for clearing CMOS values and resetting BIOS.
How to enter the BIOS Setup program during system startup.
Predefined overclocking configurations for performance enhancement.
Manual adjustment of CPU base clock and frequency.
Controls system clock frequency affecting CPU, PCIe, and memory.
Options for setting CPU frequency and clock ratio.
Configuration for Intel Turbo Boost technology and related limits.
Settings for Intel CPU power-saving technologies.
Enables reading SPD data from XMP modules for enhanced performance.
Adjusts memory multiplier and frequency for optimal performance.
Allows detailed adjustment of memory timings and voltages.
Configures fan speed for the CPU_FAN connector.
Controls fan speeds for SYS_FAN1, SYS_FAN2, and SYS_FAN3 connectors.
Specifies the boot sequence for operating systems and devices.
Settings for Intel Execute Disable Bit, Virtualization, and TXT.
Selects between UEFI and legacy boot modes for OS installation.
Allows setting administrator and user passwords for BIOS access.
Configures the xHCI controller mode for USB 3.0 devices.
Configures SATA controllers, including IDE, RAID, and AHCI modes.
Settings for system behavior after AC power loss and keyboard/mouse wake-up.
Configures ErP mode for low power consumption and ASPM.
Options to save changes, exit without saving, or load defaults.
How to set SATA controller mode (IDE, AHCI, RAID) in BIOS.
Detailed steps for configuring RAID using UEFI interface.
To Next Page