Gigabyte GA-Z97X-UD3H - Page 62

Conguring SATA Hard Drive(s)
- 62 -
Step 2:
IfyouwanttocongureUEFIRAID,followthestepsin"C-1."ToenterthelegacyRAIDROM,savethesettings
and exit BIOS Setup. Refer to "C-2" for more information.
The BIOS Setup menus described in this section may differ from the exact settings for your motherboard.
The actual BIOS Setup menu options you will see shall depend on the motherboard you have and
the BIOS version.
B.ConguringSATAcontrollermodeinBIOSSetup
MakesuretoconguretheSATAcontrollermodecorrectlyinsystemBIOSSetup.
Step 1:
Turnonyourcomputerandpress<Delete>toenterBIOSSetupduringthePOST(Power-OnSelf-Test).Go
to Peripherals\SATAConguration, make sure Integrated SATA Controller is enabled. To create RAID, set
SATA Mode Selection to RAID(Figure1).IfyoudonotwanttocreateRAID,setthisitemtoIDE or AHCI.
Figure 1