Gigabyte GS27F - Getting Started; Installing the Stand Base

- 6 -
GETTING STARTED
InstallingtheStandBase
1. Position the monitor face down on a flat surface with its protective foam
underneath and with its Styrofoam bag covered.
2. Fit the stand riser and stand base together with a coin, a screwdriver, or the
pull ring attached on the stand base.
3. Tear apart the Styrofoam bag. Fit the stand riser to the groove on the back of
the monitor. Push the stand until it snaps into place.
4. Take the monitor from the protective foam by holding its stand riser. Place it
upright on a table.