Gigabyte H262-NO0 - Installing the Memory; MM Population Rule

- 33 - System Hardware Installation
3-7-2 Installing the Memory
3-7-3 MM Population Rule
BesuretoinstallDDR4DIMMsonthismotherboard.
• The initial DIMMs installed must be installed in the primary CPU (CPU0) memory slots rst.
• When populating DIMMs into a channel, slot numbers having the sufx "0" must be populated rst,
then
followed by slot numbers having the sufx "1".
• A combination of LRDIMMs and RDIMMs is not allowed in the same channel.
• A combination of non-3DS and 3DS LRDIMMs is not allowed in the same channel.
Type
Ranks Per DIMM
and Data Width
DIMM Capacity (GB)
Speed (MT/s); Voltage (V);
Slots per Channel(SPC) and DIMM per Channel
(DPC)
DRAM Density 1DPC 2DPC
8Gb 16Gb 1.2V 1.2V
RDIMM
SRx8 8GB 16GB
3200
SRx4 16GB 32GB
DRx8 16GB 32GB
DRx4 32GB 64GB
RDIMM3DS (4R/8R)x4
2H-64GB 2H-128GB
4H-128GB 4H-256GB
LRDIMM QRx4 64GB 128GB
LRDIMM
3DS
QRx4 2H-64GB 2H-128GB
(4R/8R)x4 4H-128GB 4H-256GB
Before installing a memory module, make sure to turn off the computer and unplug the power
cord from the power outlet to prevent damage to the memory module.
Be sure to install DDR4 DIMMs on this motherboard.
Follow these instructions to install the Memory:
1. Insert the DIMM memory module vertically into the DIMM slot, and push it down.
2. Close the plastic clip at both edges of the DIMM slots to lock the DIMM module.
3. Reverse the installation steps when you want to remove the DIMM module.
1
2
2