Gigabyte H282-ZC0 - Expansion Node

- 37 - System Hardware Installation
3-10-2 Expansion Node
Follow these instructions to install the expansion node PCIe card:
1. See 3-2 Removing the Expansion Node to remove Expansion node from the system.
2. Remove the ve screws on the expansion node.
3. Lift up the riser bracket out of expansion node.
4. Remove the screw securing the side bracket to the riser bracket.
5. Remove the side bracket
6. Align the PCIe card to the riser guide slot and push in the direction of the arrow until the PCI-E card
sits in the PCI card connector.
7. Secure the PCIe card with a screw.
8. Install the side bracket to the riser bracket.
9. Secure the side bracket to the riser bracket with a screw.
10. Reverse steps 1 - 2 to install the riser bracket back into the system.
1
2
3
4
5