Gigabyte H282-ZC0 - Installing and Removing an M.2 Solid State Drive

- 39 - System Hardware Installation
3-12 Installing and Removing an M.2 Solid State Drive
Follow these instructions to install an optional M.2 solid state drive (SSD):
1. PlacethesolidstatedriveintotheM.2connector.
2. Securethesolidstatedrivetothemotherboardwithasinglescrew.
NOTE: ThepositionofthescrewwilldependonthesizeoftheSSD.Refertothe
secondimage   belowforproperplacement.
3. Reversesteps1-2toremovethesolidstatedrive.
1
2
3
NOTE:
To install/remove the M.2 heatsink use a No. 1 Phillips-head screwdriver with a screw torque of
1.5 ± 0.2 kgf*cm