Press the 4
black tubes
on cooler to
fix it on the
rank / 將風扇
上的四個黑色
短管壓下，好將
風扇固定在
CPU 上
Install fan on top of CPU / 將 CPU 風扇放在 CPU 上
5-2. After CPU is secured tightly onto the CPU socket, release the transversal lever and
attach it to the CPU socket The CPU fan must be tightly attached on the CPU to
maximize the effect of heat dispersion. Connect fan power connector to CPU FAN
on the motherboard.
當CPU 與插座已完全密合後，請將橫桿放下並勾緊 CPU 插座。組裝 CPU 風扇時必須將風扇
盡可能貼緊 CPU，以達最佳散熱效果。將 CPU 風扇接頭連接到主機板上標示為 CPU FAN 處。
A. For LGA 755 processor / 安裝 LGA 755 處理器
B. For Socket 478 processors / 安裝 Socket 478 處理器
0 When connecting the cooler power connector, please locate a 4-pins socket
next to the “CPU FAN” mark on motherboard.
連接風扇接頭時，主機板上標示”CPU FAN”字樣旁的 4 針插座即為風扇接頭連接處。
■ Other Instructions / 其他注意事項
For those models with front audio module:
系統已安裝前方USB+音源模組者：
If you use microphone for recording, please insert it in the Front Audio Port.
若您要使用麥克風錄音，請將麥克風連接至前方的麥克風插孔。
Connect the cooler power connector to CPU FAN on the motherboard
將 CPU 風扇接頭連接到主機板上標示為 CPU FAN 處
Click the heat sink locker to
the motherboard retention
module.
將風扇卡勾固定在風扇支架上
To Previous Page
Loading...
