Need help?Do you have a question about the Gigabyte W331-Z00 and is the answer not in the manual?
Detailed information & steps about installation, configuration, and use of the product.
Detailed information about installation & use of add-on hardware or software component.
A short guide with visual diagrams for installation purposes.
Gives bits and pieces of additional information related to the current topic.
Gives precautionary measures to avoid possible hardware or software problems.
Alerts you to any damage that might result from doing or not doing specific actions.
Provides warnings about electric shock and equipment damage.
Warns about potential personal injury from hot surfaces.
Provides cautionary advice for system operation.
Emphasizes caution when handling ESD-sensitive components.
Instructions for safely powering the system on and off.
Warns about electrical hazards with cables.
Discusses ESD risks and necessary protection measures.
Specific guidance on handling circuit boards to prevent ESD damage.
Instructions for manipulating jumpers on the motherboard.
Explains disposal requirements for waste electrical equipment.
Discusses compliance with RoHS standards.
Warns about chemicals in the product related to California law.
Specific warning regarding battery handling and disposal.
Read the user manual and follow procedures to avoid damage to computer or injury.
Identifies front panel components like USB 3.2 Ports, Line Out, Mic In, Power Button, and LEDs.
Guidelines to avoid damage from ESD and ensure safety when working inside the computer case.
Explains the motherboard's 4 DDR4 slots and support for Dual Channel Technology.
Diagram labeling various motherboard components with numerical identifiers.
Lists function keys for navigating and interacting with the BIOS Setup utility.
Options available: AHCI, RAID. Default setting is AHCI.
Changes CPU performance mode. Options: Standard, Performance.
Press [Enter] to configure advanced items.
Press [Enter] to configure the administrator password.
Press [Enter] to configure the user password.
Press [Enter] to configure advanced items.
Lists beep codes for PEI phase indicating memory or firmware issues.
Lists beep codes for DXE phase indicating password or protocol errors.
To Next Page
General
