Gigabyte ME03-CE0 - Page 64

BIOS Setup
- 64 -
Parameter Description
MBACongurationMenu
(continued)

Link Speed
– Congureslinkspeed.
– Options available: AutoNeg, 10Mbps Half, 10Mbps Full, 100Mbps
Half, 100Mbps Full. Default setting is AutoNeg.

Pre-boot Wake On LAN
– ConguresPre-bootWakeonLAN(WOL).
– Options available: Disabled, Enabled. Default setting is Enabled.

VLAN Mode
– ConguresthevirtualLAN(VLAN)mode.
– Options available: Disabled, Enabled. Default setting is Disabled.

VLAN ID
– CongurestheVLANID(1…4094).
– This item is available only when VLAN Mode is Enabled.
iSCSIBootCongurationMenu
Press[Enter]tocongureadvanceditems.
Blink LEDs
IdentiesthephysicalnetworkportbyblinkingtheassociatedLED.
Pressthenumerickeystoadjustdesiredvalues.
Chip Type
DisplaysthetechnicalspecicationsfortheNetworkInterfaceController.
PCI Device ID
DisplaysthetechnicalspecicationsfortheNetworkInterfaceController.
Bus:Device:Function
DisplaysthetechnicalspecicationsfortheNetworkInterfaceController.
Link Status
Speciesthelinkstatusoftheport.
Permanent MAC Address
Displays the MAC address of the Ethernet controller.
Virtual MAC Address
Displays the virtual MAC address of the Ethernet controller.