Gigabyte R272-Z31 - Page 11

- 11 - Hardware Installation
Expansion Slot
(R272-Z32)
 Total 6 x low prole PCIe Gen4 / Gen3 expansion slots
 Slot_6: 1 x PCIe x16 (Gen4 x16 bus) slot; Occupied by CNV3024, 4 x NVMe HBA
 Slot_5: 1 x PCIe x16 (Gen4 x8 bus) slot
 Slot_4: 1 x PCIe x16 (Gen4 x16 bus) slot; Occupied by CNV3024, 4 x NVMe HBA
 Slot_3: 1 x PCIe x16 (Gen4 x16 bus) slot; Occupied by CNV3024, 4 x NVMe HBA
 Slot_2: 1 x PCIe x8 (Gen3 x0 or x8 bus) slot; no function
 Slot_1: 1 x PCIe x16 (Gen3 x16 or x8 bus) slot; Occupied by CNV3024, 4 x
NVMe HBA
 1 x OCP 2.0 mezzanine slot with PCIe Gen3 x16; Occupied by CNV3024, 4
x NVMe HBA
 2 x M.2 slots:
- M-key
- PCIe Gen3 x4
- Supports NGFF-2242/2260/2280 cards
Storage
(R272-Z30)
Total 14 x 2.5" SATA/SAS hot-swappable HDD/SSD bays
 Front side: 12 x 3.5" SATA/SAS hot-swappable HDD/SSD bays ( 8 x from optional
SAS HBA and 4 x from onboard SATA ports)
 2.5" HDD/SSD supported
 Rear side: 2 x 2.5" SATA/SAS hot-swappable HDD/SSD bays ( from onboard
SATA ports)
 Front side default conguration supports:
 4 x SATA drives
 8 x SAS drives via optional SAS HBA
SAS card is required for SAS devices support
4 x SATA in front side and 2 x SATA in rear side are available in default setting
(R272-Z31) Total 26 x 2.5" SATA/SAS hot-swappable HDD/SSD bays
 Front side: 24 x 2.5" SATA/SAS hot-swappable HDD/SSD bays
 Rear side: 2 x 2.5" SATA/SAS hot-swappable HDD/SSD bays
 All devices are connected with SAS expander
 Onboard SAS35x36R expander
 Bandwidth: SATAIII 6Gb/s or SAS 12Gb/s per port
 Default conguration supports:
 0 x SAS/SATA drives
Please select SAS card to enable the drive bays
(R272-Z32)  Total 26 x 2.5" hot-swappable HDD/SSD bays
 - Front side: 24 x 2.5" NVMe hot-swappable SSD bays
 - Rear side: 2 x 2.5" SATA/SAS hot-swappable HDD/SSD bays
SAS  Supported via add-on SAS Card