Please follow the reference sections in order for installation
4-1-1 4-1-2
4. Installation Instruction
4-1 Installation of Power Supply
To facilitate the installation, it is recommended to set the chassis upright on the table.
Required parts: power supply securing screws x 4
4-1-1 Unscrew the thumbscrews of
the side panel and detach the
panel by press the latch to
remove the side panel.
4-1-2 Place the power supply unit
into the case.
4-1-3 Secure the power supply unit
with screws from the rear of
chassis.
4-1-4 When using large power supply
unit, please disassemble the
cross bar by loosing screws.
Fasten the screws to secure the
cross bar after the power supply
installed.
4-2 Installation of Motherboard
SUMO 4192 / SUMO 4198 is compatible with the ATX / Micro ATX motherboards.
SUMO 5115 is compatible with the
E-ATX / CEB / ATX / Micro ATX
motherboards.
Please confirm the dimension and fixing points of the motherboard before installation.
Required parts: Copper stand offs, securing screws
4-2-1 According to motherboard
specifications, select proper
screws points, engage the copper
stand off into the corresponding
points of the motherboard tray.
4-2-2 Change the motherboard I/O
bracket at the rear of the slot
panel (typically supplied by motherboard manufactures)
4-2-3 Secure the motherboard with securing screws.
4-2-1 4-2-2
4-2-3
Motherboard Code on tray Securing screw Copper stand off
ATX A1-A9 9 9
Micro ATX U1-U9 9 9
CEB(SUMO 5115) E1-E8 8 8
E-ATX(SUMO 5115) E1- E12 12 12
4-1-3 4-1- 4
To Next Page
Loading...