Gigabyte TRX40 DESIGNARE - Page 15

- 15 -
Hardware Installation
Step 8:
AfterinstallingtheCPU,usetwongerstopushdown
on the upper portion of the sides of the CPU carrier
frame to fasten the rail frame back to the CPU socket.
Step 9:
Closethemetalloadplate.Withonengerpressing
down on the load plate, begin tightening Screw 1
slightly. Then do the same to Screw 2 and Screw 3.
Next, fully tighten the three screws. Make sure the
motherboard is placed on a stable surface during
the tightening process.
Step 6:
Push the carrier frame into place and you will hear a
"click" sound when it is pushed to the bottom.
Warning! The CPU carrier frame cannot be placed
outside the rails.
Step 7:
Remove the CPU socket cap.