Gigabyte TRX40 DESIGNARE - Page 63

- 63 -
Conguring a RAID Set
Step 2:
After the system reboot, enter BIOS Setup again. Then enter the Settings\IOPorts\RAIDXpert2Conguration
Utility sub-menu (Figure 3).
Step 3:
OntheRAIDXpert2CongurationUtilityscreen,press<Enter>onArray Management to enter the Create
Array screen. Then, select a RAID level (Figure 4). RAID levels supported include RAID 0, RAID 1, and RAID
10 (the selections available depend on the number of the hard drives being installed). Next, press <Enter> on
Select Physical Disks to enter the Select Physical Disks screen.
Figure 3
Figure 4