Gigabyte X299-WU8 - Peripherals

BIOS Setup
- 59 -
2-6 Peripherals
& Initial Display Output
 SpeciestherstinitiationofthemonitordisplayfromthePCIExpressgraphicscards.
PCIe1Slot SetsthegraphicscardonthePCIEX16_1slotastherstdisplay.(Default)
PCIe2Slot SetsthegraphicscardonthePCIEX8_1slotastherstdisplay.
PCIe3Slot SetsthegraphicscardonthePCIEX16_2slotastherstdisplay.
PCIe4Slot SetsthegraphicscardonthePCIEX8_2slotastherstdisplay.
PCIe5Slot SetsthegraphicscardonthePCIEX16_3slotastherstdisplay.
PCIe6Slot SetsthegraphicscardonthePCIEX8_3slotastherstdisplay.
PCIe7Slot SetsthegraphicscardonthePCIEX16_4slotastherstdisplay.
& OnBoard LAN Controller (LAN2)
 EnablesordisablestheonboardLANfunction.(Default:Enabled)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to
Disabled.
& EZ RAID
 AllowsyoutoquicklysetupaRAIDarray.RefertoChapter3,"ConguringaRAIDSet,"forinstructions
onconguringaRAIDarray.
& Above 4G Decoding
 Enablesordisables64-bitcapabledevicestobedecodedinabove4GBaddressspace(onlyifyoursystem
supports64-bitPCIdecoding).SettoEnabled if more than one advanced graphics card are installed and
theirdriversarenotabletobelaunchedwhenenteringtheoperatingsystem(becauseofthelimited4GB
memoryaddressspace).(Default:Disabled)
& LEDs in System Power On State
Allows you to enable or disable motherboard LED lighting when the system is on.
Off Disables the selected lighting mode when the system is on.
On   Enablestheselectedlightingmodewhenthesystemison.(Default)