Gigabyte X570S AERO G - Back Panel Connectors

1-7 Back Panel Connectors
USB 2.0/1.1 Port
The USB port supports the USB 2.0/1.1 specication. Use this port for USB devices.
SMA Antenna Connectors (2T2R)
Use this connector to connect an antenna.
DisplayPort In Port
The DisplayPort In port offers video outputs to the motherboard. Refer to the USB Type-C
®
(USB 3.2
Gen 1) port for more information.
HDMI Port
(Note 1)
The HDMI port is HDCP 2.3 compliant and supports Dolby TrueHD and DTS HD
Master Audio formats. It also supports up to 192KHz/24bit 7.1-channel LPCM
audio output. You can use this port to connect your HDMI-supported monitor. The maximum supported
resolution is 4096x2160@60 Hz, but the actual resolutions supported are dependent on the monitor being
used.
After installing the HDMI device, make sure to set the default sound playback device to HDMI.
(The item name may differ depending on your operating system.)
USB 3.2 Gen 1 Port
The USB 3.2 Gen 1 port supports the USB 3.2 Gen 1 specication and is compatible to the USB 2.0
specication. Use this port for USB devices.
USB 3.2 Gen 1 Port (Q-Flash Plus Port)
The USB 3.2 Gen 1 port supports the USB 3.2 Gen 1 specication and is compatible to the USB 2.0
specication. Before using Q-Flash Plus
(Note 2)
, make sure to insert the USB ash drive into this port rst.
USB Type-C
®
Port
This port supports GIGABYTE VisionLINK technology and has display and data transmission capabilities
with 20V@3A of power delivery. You can connect a drawing tablet to this port. This port also supports
standard USB Type-C
®
and DisplayPort display output. You can connect a USB Type-C
®
monitor to this port
or use an adapter cable to connect a standard DisplayPort monitor. The maximum supported resolution is
4096x2304@60 Hz when using a DisplayPort monitor, but the actual resolutions supported are dependent
on the monitor being used. The reversible USB port supports the USB 3.2 Gen 1 specication and is
compatible to the USB 2.0 specication. You can use this port for USB devices, too.
Tighten the antennas to the antenna connectors and then aim the antennas correctly for better
signal reception.
(Note 1) For AMD Ryzen
™
4000 G-Series Processors/AMD Ryzen
™
3000 G-Series Processors/AMD Ryzen
™
2000 G-Series Processors only.
(Note 2) To enable the Q-Flash Plus function please visit the "Unique Features" webpage of GIGABYTE's
website.
- 13 -