• At least two SATA hard drives or SSDs.
(Note 1)
(To ensure optimal performance, it is recommended that you
use two hard drives with identical model and capacity).
(Note 2)
• Windows setup disk.
• Motherboard driver disk.
• A USB thumb drive.
Install the hard drives/SSDs in the Intel
®
Chipset controlled connectors on the motherboard. Then connect the
power connectors from your power supply to the hard drives.
Steps:
1. Go to , make sure is enabled. To create
to . Then
save the settings and restart your computer.
2.
The BIOS Setup menus described in this section may differ from the exact settings for your motherboard.
The actual BIOS Setup menu options you will see shall depend on the motherboard you have and
the BIOS version.
drive.
Steps:
1. After restarting the computer, enter the BIOS Setup and go to Peripherals. Press <Enter> on the
Type tab and then press <Enter>.
2. Go to the Mode
<Enter> to move to the Create tab. Click Proceed to begin.
3. After completing, you'll be brought back to the screen. Under
Volumes
Minimum
Number of Hard
Drives
2 4
Array Capacity Number of hard
smallest drive
drive
(Number of hard
the smallest drive
(Number of hard
smallest drive
Fault Tolerance No Yes Yes Yes
- 38 -
To Next Page
Loading...
