please follow the steps below:
1. After system restarts, go to the BIOS Setup, make sure CSM Support under the menu is disabled.
2. Go to and make sure is disabled. If
you want to enable the Optane
™
memory installed in the M2Q_32G connector, set
Port 21 to ; to enable the Optane
™
memory installed in the M2A_32G connector, set PCIe
to .
3. Enter the operating system, launch the Intel
®
enable Intel
®
Optane
™
Memory on the Intel
®
™
Memory screen.
4. If you install more than one Optane
™
memory, please select which one you are going to use.
5. Follow the on-screen instruction to continue the installation and then restart the system when completed.
• An Optane
™
memory cannot be used to accelerate an M.2 PCIe SSD.
• If more than one Optane
™
memory is installed, you can select only one of them to accelerate your
SATA-based boot drive. The other(s) can only be used as data drive(s).
• Do not abruptly remove the Optane
™
memory. Doing so will cause the operating system to stop
functioning correctly.
• If you want to change/remove the Optane
™
memory, you must disable it using the Intel
®
™
• After enabling the Optane
™
memory, the related BIOS settings will remain even after a BIOS update.
•
• After installing the operating system, insert the motherboard driver disk into your optical drive. Click
install. You can click the
the arrow
icon to individually install the drivers you need.
3-3 Drivers Installation
Please visit GIGABYTE's website for
more software information.
Please visit GIGABYTE's website
software.
- 41 -
To Next Page
Loading...
