Gigabyte Z490 VISION D - Page 12

- 12 -
Hardware Installation
Internal
Connectors
 1 x front panel audio header
 1 x USB Type-C
™
header, with USB 3.2 Gen 2 support
 1 x USB 3.2 Gen 1 header
 2 x USB 2.0/1.1 headers
 1 x Trusted Platform Module header (For the GC-TPM2.0 SPI/GC-TPM2.0 SPI
2.0 module only)
 2 x temperature sensor headers
 1 x Clear CMOS jumper
 1 x Q-Flash Plus button
Back Panel
Connectors
 1 x DisplayPort In port
 2 x Thunderbolt
™
3 connectors (USB Type-C
™
port, with USB 3.2 Gen 2 support)
 1 x HDMI port
 2 x SMA antenna connectors (2T2R)
 2 x USB 3.2 Gen 2 Type-A ports (red)
 4 x USB 3.2 Gen 1 ports
 2 x USB 2.0/1.1 ports
 2 x RJ-45 ports
 1 x optical S/PDIF Out connector
 5 x audio jacks
I/O Controller  iTE
®
I/O Controller Chip
Hardware
Monitor
 Voltage detection
 Temperature detection
 Fan speed detection
 Water cooling ow rate detection
 Overheating warning
 Fan fail warning
 Fan speed control
* Whether the fan (pump) speed control function is supported will depend on the fan
(pump) you install.
BIOS  1 x 256 Mbit ash
 Use of licensed AMI UEFI BIOS
 PnP 1.0a, DMI 2.7, WfM 2.0, SM BIOS 2.7, ACPI 5.0
Unique Features  Support for APP Center
* Available applications in APP Center may vary by motherboard model. Supported
functions of each application may also vary depending on motherboard specications.
- @BIOS
- EasyTune
- Fast Boot
- Game Boost
- ON/OFF Charge
- RGBFusion
- Smart Backup
- System Information Viewer
- USB DAC-UP 2