Gigabyte Z490 VISION D

To Next Page

To Previous Page

- 65 -

Conguring a RAID Set

C-1. Using EZ RAID

GIGABYTEmotherboardsprovideyouwiththeEZRAIDfeature,allowing you toquicklycongureaRAID

arraywithsimpliedsteps.

Step 1:

After restarting the computer, enter the BIOS Setup and go to Settings. Press <Enter> on the EZ RAID item.

SelectthetypeofharddrivesyouuseforRAIDintheType tab and then press <Enter>. (Figure 2)

Figure 2

Figure 3

Step 2:

Go to the ModetabtoselectaRAIDlevel.RAIDlevelssupportedincludeRAID0,RAID1,RAID10,andRAID5

(the selections available depend on the number of the hard drives being installed). Then press <Enter> to move

to the Create tab. Click Proceed to begin (Figure 3).

Gigabyte Z490 VISION D - Page 65