Gigabyte Z490 VISION D - Page 78

- 78 -
Conguring a RAID Set
B. Rebuilding an Array
Rebuildingistheprocessofrestoringdatatoaharddrivefromotherdrivesinthearray.Rebuildingappliesonly
tofault-tolerantarrayssuchasRAID1,RAID5orRAID10arrays.Theproceduresbelowassumeanewdrive
isaddedtoreplaceafaileddrivetorebuildaRAID1array.(Note:Thenewdrivemusthaveequalorgreater
capacity than the old one.)
Turnoffyourcomputerandreplacethefailedharddrivewithanewone.Restartyourcomputer.
• Performing the Rebuild in the Operating System
While in the operating system, make sure the chipset driver has been installed from the motherboard driver
disc. Then launch the Intel
®
RapidStorageTechnologyutilityfromtheStartmenu.
Step 1:
Go to the Manage menu and click Rebuild to
another disk in Manage Volume.
The Status item on the left of the screen displays
therebuild progress.After the RAID 1 volume
rebuilding, the Status will display as Normal.
Step 2:
SelectanewdrivetorebuildtheRAIDandclick
Rebuild.