21 Washington Ave
Scarborough, ME 04074
888.293.2121
sales@myerstest.com
myerstest.com
22
SAFETY INSTRUCTIONS
Whether you are the owner, employer, operator, or maintenance person for this machine, safety is your
responsibility. You are responsible for operating and maintaining this equipment in compliance with
these instructions and for using common sense. Review and completely understand the operating and
safety instructions before using this machine.
WARNING!
This machine operates on electric current. Improper operation could result in electric shock,
electrocution, or an explosion!
1. ALWAYS ensure the motor and other electrical components are properly congured for your
intended use and available power source. The Gilson SS-20 Rotary Sifter comes with a 1/4hp
motor wired for 115V/60Hz. The SS-20F model operates on 230v/50Hz power supplies. Motors
are NOT explosion-proof.
2. ALWAYS check electrical wiring for loose connections and for pinched or frayed wiring.
3. ALWAYS use the factory-installed three-pronged plug. Connect the machine to a properly wired
and grounded three-pronged receptacle. Make sure the cord is located where no one will trip or
get tangled in it.
4. ALWAYS disconnect and lock out power supply before performing maintenance and repairs.
WARNING!
WARNING: DO NOT operate the machine without having all covers and cabinet in place.
WARNING: Stop the machine immediately if excessive noise, vibration or machine movement occurs.
WARNING: The electric motor on this machine has internal thermal protection. If the motor shuts
off from overload, the machine may restart by itself after cooling off, unless the machine is unplugged
during cool-down.
WARNING: ALWAYS unplug or disconnect machine from the power source when the unit is not in
operation.
WARNING: Keep all parts of your body away from moving parts of th Table of Contents
Safety Instructions
Table of Contents
1.0 Introduction
To Next Page
Loading...