30
Picture 7 Picture 7-1 Picture 7-2
b. Alternatively, press “MEM” button in Clock Mode to display the stored results.
The current memory bank will blink and the amount of results in this bank will
be displayed. See picture 7-1. Press “START” button to change over to other
bank. See picture 7-2. Conrm your selection by pressing “MEM” button. The
current bank can also be conrmed automatically after 5 seconds with no
operation.
c. After selecting the memory bank, the LCD will display the average value of
the last three results in this bank, See picture 7-3 &7-4. If no result stored,
LCD will show dashes as picture 7-5.
Picture 7-3 Picture 7-4 Picture 7-5
d. When the average is displayed, press the “MEM” button, the most recent
result will be displayed. See picture 7-6. Followed by, the blood pressure
and pulse rate will be shown separately. Irregular heartbeat symbol (if any)
will blink. See picture 7-7&7-8. Press “MEM” button again to review the next
result. See picture 7-9. In this way, repeatedly pressing the “MEM” button
displays the respective results measured previously.
Picture 7-6 Picture 7-7
ENGLISH
To Next Page
Loading...
