11
Installing the Battery
Batteries may not be preinstalled in the meter. Two CR 2032 3.0 V coin cell
batteries are required. Please find the batteries in your carrying case and install
them according to the following steps:
1. Turn over the meter to locate the battery cover. Slide the battery cover in the
direction of the arrow to open it.
2. Insert two new CR 2032 3.0 V coin cell batteries on top of the plastic tape.
Make sure it is aligned with the plus (+) side facing up in the battery carrier.
3. Close the battery cover and make sure that it snaps shut.
To Next Page
Loading...