Speed limitations
You must check your local laws and regulations to determine if it is
lawful to ride class 3 e-bikes on public roads before adjusting the bike’s
top speed. Laws vary by trail, path, and road so be sure to check in each
new location you will be riding. Also. If your local laws does not support
throttle then please disable it from programme mode P10 by choosing 0
for only pedal assistance mode.
1. Access the settings menu by pressing and holding the up and down
arrows on the control pad simultaneously until the screen says "P1"
2. From here you can cycle through settings by hitting the "m" button on
the control pad and adjust the settings by pressing the up or down
arrows on the control pad
3. Please go to setting "P08" and change this setting (it is in KMPH and
not miles). For example UK default speed should be 24.9 KMPH
4. Press and hold the up and down arrows on the control pad until the
main screen is shown once again
5. Power the bike off by holding the “M” button to save the settings you
have just changed
Battery Capacity Display On the top of the LCD display (battery bar).
This battery indicator shows the estimated charge level left in the bike's
battery. As the battery depletes, tick marks will begin to disappear
according to approximately how much charge in the battery has been
used. The battery display will flash when there is no charge remaining.
Note: The energy bar will not always be accurate. The energy bar
updates every few minutes based on the current voltage of the battery
16
To Next Page
Loading...