Now is also a perfect time to double check that all the electrical
connections on your scooter are secure. Reconnect any separated
connection or tighten any loose ones. Please note there will be extra
connections on the controller, not used in the function of your scooter.
With the trim removed align the holes on the backrest support with
those on the frame and secure into place with bolts (c). Replace the
trim, making sure it is tucked under the main body(it will not line up
correctly otherwise) and replace the screws holding it in place.
Replace the seat and secure it back into place with the bolts removed
early from the seat tray. At this point check the connections on the
breaker, tightening if necessary, and turn the breaker to the on position,
it will now charge or work otherwise.
13
To Next Page
Loading...
